KOYOFEI 3PCS LCD Screen Tempered Glass Protective Film for 7 inch Resin 3D Printer, High Light Transmittance Protective Film for Elegoo Mars 4, Mars 4 Ultra, Mars 5, Mars 5 Ultra LCD 3D Printer

[ad_1]
7 Inch Monochrome Screen Tempered Film for Elegoo Mars 4, Mars 4 Ultra, Mars 5, Mars 5 Ultra resin 3d printers.
Installation instructions:
Installation of the tempered glass screen protector
1.Tear off the black shading tape and dirty screen protector, then clean the curing screen with tool set.
A. Wipe the screen with alcohol prep pad
B. Wipe the screen with a dry cloth
C. Use dust absorbers to remove fine dust.
2. Peel off the back of the screen protector, align the protector to the edge of the screen and stick it from one end to the other. Bring the installation carefully without air bubbles.
3. Reattach the shading tape and clean the front of the screen protector with tool kit.
Compatible Models: Only Compatible with Mars 4/Ultra, Mars 5/Ultra.
Package： 3PCS Tempered Glass Screen Protector, 3PCS Tool Kit, 1x manual.
Compatible Models: 7 inch tempered glass screen protector is only compatible with Elegoo Mars 4, Mars 4 Ultra, Mars 5, Mars 5 Ultra. It comes with tool kit and manual, please read the introduction of the manual before installation.
With good protection, the tempered film can not only protect the monochrome screen from being scratched by sharp objects in daily use, but also prevent the resin from leaking and polluting the screen from the damage of the release film.
The light transmittance of the tempered film is 95%, which will not affect the light of the monochromatic screen to cure the resin in the resin tank through the tempered film.
Easy to use, the back of the tempered film is covered with a protective film. Please keep the screen clean before use, then remove the back protective film and install the tempered film on the monochrome screen. Use a plastic scraper to avoid air bubbles. After the installation is completed, please use cleaning fluid and The non-woven fabric wipes the tempered film clean.
Small Tips:The tempered film has a thickness of 0.35mm. Before installation, please remove the black shading tape, remove the old screen protector, install the new tempered film, and reattach the shading tape. In order to avoid printing problems, it is recommended to level the 3D printer again after installing the tempered film.

[ad_2]